Denon PMA-SA1 - Manual (Page 10)

10
ENGLISH ENGLISH
3 OPERATION
(Refer to page 5.)
PREPARATION
1. CHECKING CONNECTIONS
• Make sure that all the connections are proper by referring
to the rear panel.
• Check the polarity (positive and negative) of connections,
and the directivity of stereo separation (right cord to right
channel terminal, and left cord to left channel terminal).
• Check the directivity of pin plug cord connection.
2. SETTING OF EACH KNOB
• Turn the VOLUME knob
t
counterclockwise, to minimum
position.
After checking the above items, turn on the power, the amplifier
is set in the ready mode in a few seconds.
PLAYING A RECORD
1. Set the EQ POWER switch
e
to “ON”.
2. Set the INPUT SELECTOR switch
i
to “PHONO”.
3. Operate the turntable and play the record.
4. Turn the VOLUME knob
t
to yield an appropriate volume.
PLAYING CD PLAYER
1. Set the INPUT SELECTOR switch
i
to “CD-1”.
2. Operate the CD player.
3. Turn the VOLUME knob
t
to yield an appropriate volume.
PLAYING CD PLAYER
1. Set the INPUT SELECTOR switch
i
to “CD-2”.
2. Operate the CD player.
3. Turn the VOLUME knob
t
to yield an appropriate volume.
RECEPTION OF RADIO PROGRAMS
1. Set the INPUT SELECTOR switch
i
to “TUNER”.
2. Operate the tuner to receive a radio program.
3. Turn the VOLUME knob
t
to yield an appropriate volume.
PLAYING AUDIO EQUIPMENT CONNECTED TO
DVD/AUX TERMINALS
1. Set the INPUT SELECTOR switch
i
to “DVD/AUX” position.
2. Operate the Audio equipment.
3. Turn the VOLUME knob
t
to yield an appropriate volume.
PLAYING AUDIO EQUIPMENT CONNECTED TO
BALANCED INPUT TERMINALS
1. Set the BALANCED INPUT switch
y
to “ON”.
2. Operate the Audio equipment.
3. Turn the VOLUME knob
t
to yield an appropriate volume.
PLAY BACK WITH TAPE DECK
1. Set the INPUT SELECTOR switch
i
to “TAPE-1/CD-R” or
“TAPE-2/MD”.
2. Operate the tape deck.
3. Turn the VOLUME knob
t
to yield an appropriate volume .
RECORDING WITH TAPE DECK
1. Set the BALANCED INPUT switch
y
and INPUT SELECTOR
switch
i
to the program source you wish to record.
2. Set the REC OUT SELECTOR switch
u
to “SOURCE”.
3. Play back the program source.
4. Start recording with the component connected to “TAPE-
1/CD-R” or “TAPE-2/MD”.
COPYING FROM ONE TAPE TO ANOTHER
To copy from TAPE-1/CD-R to TAPE-2/MD, set the REC OUT
SELECTOR switch
u
to “TAPE-1 1 2”.
To copy from TAPE-2/MD to TAPE-1/CD-R, set the REC OUT
SELECTOR switch
u
to “TAPE-2 1 1”.