Q-See QSZ515D - Manual (Page 2)

Lens 1.3 Megapixel 5-15mm F2.2 2.0MP auto focus lens
White Balance Auto
BLC Open
Video Output 1.0V P-P,75Ω BNC
AGC Auto
Power Voltage Super Wide Voltage (8V~18V)
Input Current DC12V+/_20% 50/60Hz, 1.2A above
Output Current 12V 800mA
Operating Temperature
14°F to 122°F (-10°C to 50℃)
（relative humidity: up to 95%）
Storage Temp -22°F to 158°F (-30°C to 70°C)
Color White
Dimensions(LXD) 5x5 in (125×125mm)
Weight 2.2 lbs (1KG) （without bracket and adapter）
Address Range 1-256
Module Index of Variable Speed Pan/Tilt/Zoom:
1. Horizontal scanning: 360°rotation
2. Horizontal speed: 0.5°—50°/s
3. The lowest speed at 0.5°/s, no vibrating images
3. Vertical scanning: >90°
4. Vertical speed: 0.5°—30°/s
5. 128 preset positions (PTZ and vari-focal lens included)
6. Speed of preset positions: 50°/s
7. PTZ scanning precision: ±0.5°
8. 3X zoom
Control Protocol:
PELCO“P”Protocol
PELCO“D”Protocol
Baud Rate : 1200b/2400b/4800b/9600b
Built-in Decoder
1. Full digital design, all data saved inside of the module with memory
function in case of accidental power loss.
2. All in one integrated design, high reliability
3. 128 preset positions can be saved
4. 1-80 preset positions support auto cruise function, while 1 cruise route
can save 8 preset positions, each position pauses 6 seconds.
5. Uses RS485 remote control interface
6. Thanks to its expanding function, any keyboard can operate the controls
of this high speed dome.
Part 2 Functions & Operating Instructions
This part mainly describes the leading functions and common
principles of the all in one intelligent dome camera. It does not refer to t
he specific operating methods. Different systematical
platforms have different methods. In some cases, special
requirements and operating methods would exist, subject to the
product manual.
1. 1. Set CCTV encoding
The control board of the dome has a 10-DIP-switch, used to set
address, communication and control protocols PELCO-D/P (refer to “DIP switch
set”). Any command should agree with the targeted
address, and cameras only response when address code is the same.
2. CCTV Camera Operation
2. Zoom control
User can adjust the image farther/nearer to get a panoramic view by contr
olling the keyboard buttons ZOOM- / ZOOM+ . The speed dome supports b
oth digital and optical vari-focus. Digital vari-focus can be set.
In the following cases, the camera’s target is unable to auto
Focus:
1. The target is not in the center of the image;
2. When watching the farther or nearer objects, the objects are not clear;
3. The target is a strong light, like neon light, spot light etc;
4. The object moves to fast;