3DLABS VP - Manual (Page 10)

Installation
Connecting one or more VGA or Digital Video Interface (DVI) monitors
Depending on which model of Wildcat VP Graphics Accelerator Card you purchased, you can
connect one or two VGA or Digital Video Interface (DVI) monitors to drive one or two displays.
Check your product’s packaging or the datasheet on the 3Dlabs website to determine how many and
which type of connectors are included. See the drawings below for the different type of connectors.
DB-15 VGA Analog Connector
Connect analog displays using a cable with a
VGA connector.
DVI-I Connector
Connect digital or analog displays using a cable
with a DVI-D or DVI-I connector.
If you connecting an analog monitor to the DVI-I connector, then you may need a DVI to analog
adapter. This adapter may have been included with your Wildcat VP Graphics Accelerator Card. You
can find information about obtaining these adapters on the 3Dlabs Web site.
Attaching a Stereo Device
If your Wildcat VP Graphics Accelerator Card supports stereo viewing, then connect the stereo hardware
to the round stereo connector on the card. See the documentation that came with your stereo hardware.
Plug in and start up your system, including peripherals, and log on to your operating system.
3-Pin
Minidin
Stereo
Connector
3Dlabs Wildcat VP Graphics Accelerator Card User's Manual 4