Acrosser AR-V5403FL - Manual (Page 35)

Revision: 1.0
35
Another function of Smart Mode
1. If ignition turns back “ON” during “Off” Delay, Power smart function will stay in operation.
“Off” signal will not be send to motherboard. The “Off” Delay will re-start after next
ignition off.
2. Power input monitoring (before system boot on, during runtime, during soft off delay):
The Power smart function will constantly monitor the input voltage. If the input voltage is
below X Voltage (the standard might have 5% tolerance), the AR-PW0932V will not
start the power on procedure. When Power smart function has ran in operation and the
battery drops below Y Voltage (with 5% tolerance) more than 10 seconds the Power
smart function will shut down the motherboard following the standard shut down
procedure. If the input voltage recovers in 10 seconds over Y Voltage (with 5%
tolerance) again, the Power smart function will continue to run. (Figure 4)if this
happens, ignition shall be off and on again (Mode 2, 3, 4) or press the remote
switch(Mode 5,6,7) if you want to turn on system again.
For 12V car battery For 24V car battery
X value 11.2 23
Y value 10.8 22.5