Dacor 100500 - Manual (Page 15)


i
nsTallaTion
i
nsTRuCTions
Side Panel Installation
If using side panels with the Dacor ® Built-In Refrigerator,
they will need to be 1/4-inch thick. Slide the panel into
position and secure with screws indicated by the shaded
area. A 3/16-inch spacer is required between the cabinet
and side panel. A 1/2-inch thick by 10 1/4- inch tall spacer
is required if the side panel extends up into the machine
compartment area on the refrigerator side.
Backside of Unit
Freezer Side of Unit
Door
1/4" side panel fitted up to
the cabinet trim (top view)
on Freezer side.
3/16" (5mm)
Spacers
#8-32 1/2"
Screw
1/4" (6mm) Side Panel
1/4" side panel fitted up to
the cabinet trim (top view)
on Refrigerator side.
Backside of Unit
Refrigerator Side of Unit
1/2" (13mm) Spacers
on side of machine
compartment
[3/16" (5mm) below the
machine compartment]
Door
#8-32 1/2"
Screw
1/4" (6mm) Side Panel
Drill 3 holes through
vertical frame into
cabinetry where
applicable.
(approx. location)
a
nChoRing The
u
niT
After the door and side panels have been installed, and the unit
has been leveled and door adjustment has been completed, you
may anchor the unit to the opening.
◊ First, make sure the unit has been leveled and aligned, and
the doors are adjusted.
◊ Drill three 3/16” holes through both outer trims.
◊ Drill a 1/8” pilot hole into the cabinetry.
◊ Install screws.