American Energy Systems Inglenook - Manual (Page 5)

Version: 7.2 5
THE WARRANTY PRINTED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THE
PRODUCT. ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING,
WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, ARE DISCLAIMED. IT IS UNDERSTOOD
AND AGREED THAT AES’S LIABILITY UNDER THIS WARRANTY SHALL BE LIMITED
TO THE PROVISION OF REPLACEMENT PARTS AND SHALL NOT INCLUDE
LIABILITY FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES. ANY
ACTION BROUGHT UNDER THIS WARRANTY MUST BE BROUGHT WITHIN ONE
YEAR OF THE ACCRUAL OF THE CAUSE OF ACTION AND MAY ONLY BE BROUGHT
IN THE CIRCUIT COURT OF MCCLOUD COUNTY, MINNESOTA.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental
or consequential damage, so the above limitations may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights which vary from state to state.
ALL WARRANTY CLAIMS MUST BE SUBMITTED IN WRITING THROUGH THE PLACE WHERE
THE PRODUCT WAS PURCHASED. In the event where the place of purchase has ceased business or if
you feel that there is a legitimate reason that you cannot submit your claim to the place where the product
was purchased you may make a written request to the factory by emailing your request along with all of the
required information to [email protected] . NOTE: Verbal requests will not be recognized.
If it is determined that warranty could have been performed by the place of purchase, the factory
will deny the claim.
Included with the claim must be the following information: (if this information is not complete, the claim
will be denied)
Name, address, telephone number, email address, of place of business where product was
purchased & also purchaser contact info.
Date of purchase, model and serial number of product, digital pictures of product (front, sides,
back, venting inside and outside)
(If there is ductwork, there must be digital pictures of entire ductwork installation, static pressures,
air flow measurements, and contact information of licensed/factory certified contractor that
installed unit)
Nature of defect, what has been serviced (service record), who installed product along with contact
information.