AMT Datasouth M5DT Plus - Manual (Page 16)

14
8. Hold the lower cover and lift up the lower inner cover.
9. Thread the cutter module cable through the bezel.
10. Connect the cutter module cable to the 4-pin socket on printer PCB.
Fig. 16 Cutter module harness arrangement
11. Reassemble the lower inner cover back onto the lower cover.
12. Install the cutter module into the slots of the printer.
Fig. 17 Cutter module installation
13. Reassemble the parts in the reverse order.
14. Close the top cover.
Bezel
Socket
Slots each side of
the printer