Operating the unit – Bonaire 5 Star Silhouette User Manual
Page 6
E
LECTRONIC
S
ILHOUETTE
Page 6
Operating the Unit
Controlling the Unit
When the unit is in the on state, there are three modes of operation, Manual, Automatic and
Programming.
The mode of operation is changed by briefly touching the mode button. The mode of operation will
change from manual to automatic to program to manual.
•
Manual Mode
In this mode the user directly selects the level of heat
output and also the fan speed.
If the level and fan speed bars are not flashing, the
heating output can be changed by firstly touching the
SELECT button. The temperature bars will flash.
Then by touching either the UP or Down buttons the
level of heat output can be changed.
If the temperature bars are flashing, the fan speed
can be changed by firstly touching the SELECT
button. The fan speed bars will flash. Then by
touchng either the UP or DOWN buttons the fan
speed can be changed to low, medium or high.
In this mode the unit will continue to operate and not
shut off based on room temperature. Also, each hour
the unit will momentally turn off to conduct safety
checks and restart.
•
Automatic Mode
In this mode the heater runs at an output level set by
the user, aiming to reach the defined temperature set
point. Once the point is reached the unit will cycle on
and off to maintain the temperature.
If the temperature and fan speed bars are not
flashing, the temperature setpoint can be changed by
firstly touching the SELECT button. The temperature
bars will flash. Then by touching either the UP or
DOWN buttons the temperature setpoint can be
changed.
If the temperature bars are flashing, the fan speed
can be changed by firstly touching the SELECT
button. The fan speed bars will flash. Then by
touchng either the UP or DOWN buttons the fan
speed can be changed to low, medium or high.
•
Programming Mode
In the programming mode you can program the unit
to come on and off either once or twice in any 24
hour period, any day of the week, weekdays,
weekend or for the whole week. For each active
period the start time should enter and whether the
period is ON or OFF. ON period have set
temperature and fan speed.