Custom Autosound Secretaudio SST - Manual (Page 7)

6 9
Tuner/Amplifier Mounting
1. Choose a mounting area for the tuner/amp module that will provide plenty of ventila-
tion to prevent the amplifier from overheating. The tuner/amp module can be mounted
in the horizontal or vertical position. Please note that when mounting in vertical posi-
tion, do not mount with the harness exit points facing straight up, as this will reduce the
efficiency of the heat sink cooling.
2. Using the shortest length of the recommended size screws possible, mount the
tuner/amplifier as detailed in the diagram below.
3. Route the tuner/ amplifier harness and cable throughout the vehicle as required.
Keep some slack in the harness / cables so it won't be too tight, as this can cause
damage to the wires.
4. Follow the wiring diagram carefully and make certain all connections are secure and
insulated with crimp connectors or electrical tape to ensure proper operation.
5. After completing the wiring connections, reconnect the negative terminal on the bat-
tery and turn the unit on to confirm operation (vehicle accessory switch must be on). If
the unit does not operate, disconnect battery, recheck all wiring and refer to the trouble-
shooting guide located in the back of the manual.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Category Navigate Search
1. Short press the “button” (8) until “Category” appears on the LCD
2. Press Select (5) or rotate the Volume knob (4) to enter into Category Search.
Rotate the VOL knob clockwise for Category up, Rotate the VOL knob counter
clockwise for Category down.
3. Once the desired Category is displayed, press Select (5).
4. Rotate the VOL knob clockwise for CH up and counter clockwise for CH down. Or
press Tune Up/Dn to choose channel.
(Note: At this moment, press AS/PS (7) to go back to last level of Category selection)
5. Once the desired CH is displayed, press Select button (5) to confirm.
Channel Up/Down Tuning
Press the TUNE/TRK |<< / >>| buttons (2/3) to search for a channel. Press and hold the
TUNE/TRK buttons to fast search.
Storing Preset Channels
The preset buttons (10-15) can be used to store 6 channels, allowing convenient access
to your favorite channels. 1. Select the channel you want to store in memory.
2. Press and hold a preset button (10-15) until the corresponding preset button #
appears. 3. Repeat steps 1 and 2 to program additional channels.
Quick Tuning
Press one of the six preset buttons (10-15) to select a preset channel directly.
Channel Direct Access Searching (8)
- Press BAND button (8) to access direct tune mode, "Direct -T" appears on the display
for a few seconds.
- Rotate the Knob (4) Clockwise or Short Press Select button (5) to confirm entry into
the Direct Tune mode
- Rotate knob clockwise or counter-clockwise to navigate through number 0-9
- Default interface display is SR CH 0__
- The 1st digit only allows numeric entry from 0, 1 & 2 for Channel Number
- The 2nd & 3rd digits allow numeric entry from 0, 1 to 9 for Channel Number
- Short press Select button (5) to confirm the entry of the current digit, use Track up /
down button (2) or (3) as cursor to move back & forth among the 3 digits
continued on page 9