Da-Lite Boardroom Electrol - Manual (Page 2)

2
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
Save These Instructions
Pre-Installation
Installation
1. Carefully unpack screen and remove outer
wrapping from case.
2. Make sure to recheck measurement of screen
location before installation.
3. Remove center support brackets (on 8' and wider
screens only), reverse brackets and reinstall flush with
the top of the box.
NOTE: Unit is not to be installed in air handling space.
1. Install screen by raising unit into position between joists at
one end only. Install one lag screw or appropriate fastener in
each mounting bracket. Secure opposite end. Secure center
support brackets. Install sufficient fasteners in each bracket
for secure installation.
2. Make sure unit is level and plumb.
CAUTION! Do not secure access door or seal in unit
until screen has been secured in position and properly
tested for satisfactory operation. Do not fit unit so tightly
that the screen surface drop door binds. Door drops by
gravity only.
ATTENTION! Ne fixez pas la trappe d'accès ou ne scellez
pas l'unité jusqu'à ce qu'il ait été correctement mis en
place et qu'il fonctionne convenablement. Ne serrez pas
l'unité au point que la surface de la trappe d'accès de
l'écran soit bloquée. La trappe tombe uniquement à cause
de la gravité.
3. If you are going to cover screen door with paneling or other
materials, allow access (suitable holes or plug) to slat hook
screws (4) when servicing (Fig. 1).
4. Open access door by removing access door screws.
5. Remove junction box cover plate.
Figure 1
Slat Hook
Screws
Tape Strips
Figure 2
Fabric Door
Access
Door
Screw
Access Door
Mounting Brackets