Da-Lite Executive Electrol - Manual (Page 2)

2
Pre-Installation
1. Carefully unpack screen and remove outer wrapping
from case.
2. Remove fabric and cardboard strips from access door.
3. Remove access door by gently prying from middle section.
4. FOR TYPE 3 INSTALLATION ONLY, remove wood strips along
bottom edge of screen case.
5. Remove instruction cover (Fig. 1). Remove, reverse, and
remount Center Support Brackets.
6. Do not remove metal shipping brace (secures roller),
wrapping paper or tape until screen is installed.
NOTE: Screen is not centered in box. Screen is set
22" from motor end.
7. Make sure to recheck measurement of screen location
before installation.
Ironing Board
Executive Electrols 14' wide and over contain an ironing board to
flatten the fabric (long strip attached). The ironing board is part
of the screen case. Do not remove. Contact Da-Lite if the ironing
board is in need of adjustment. (Fig. 2).
Case
Instruction Cover
Fabric Door
Access Door
Figure 1 Figure 2
Shipping Brace
(Not On 3" Roller)
Hex Head
Screws
Tape Strip
Important Safety Instructions
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
Save These Instructions
Ironing
Board