Da-Lite Executive Electrol - Manual (Page 3)

3
Installation
1. Install screen by raising unit into position between joists
at one end only. Install one lag screw in each mounting
bracket. Secure opposite end. Support center of the screw
using the brackets.
2. Level unit lengthwise with a carpenter’s level and
a plum level.
CAUTION! Do not secure access door or seal in unit
until screen has been secured in position and properly
tested for satisfactory operation. Do not fit unit so tightly
that the screen surface drop door binds. Door drops by
gravity only.
ATTENTION! Ne fixez pas la trappe d'accès ou ne scellez
pas l'unité jusqu'à ce qu'il ait été correctement mis en
place et qu'il fonctionne convenablement. Ne serrez pas
l'unité au point que la surface de la trappe d'accès de
l'écran soit bloquée. La trappe tombe uniquement à cause
de la gravité.
3. If you are going to cover screen door with paneling or other
materials, allow access (suitable holes or a plug) to screws
when servicing.
4. Remove shipping brace by removing 3 hex head
screws (Fig. 2).
CAUTION! Do not cut wrapping paper or tape
with knife or any sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le
ruban adhésif avec un couteau ou un outil tranchant.
Retirez à la main.
5. Remove tape strips and release fabric (Fig. 2). Picture surface
should hang freely (Fig. 3). Remove any tape left hanging on
back of fabric. Bottom edge should be positioned between
bottom edge of case and center of roller.
6. Install electrical hook up that applies to your unit. Unit should
be installed by a qualified electrician.
NOTE: Must be installed in accordance with the requirements
of the Local Building Codes, the Canadian Electrical Code
(CEC), CAN/CSA C22.1 and the National Electric Code (NEC),
NFPA 70.
7. Test installation by carefully running picture surface “up”
and “down” several times. Be prepared to stop screen.
8. Make sure picture surface, when rolled down, has a full
wrap around roller. No part of roller should be exposed.
Fabric door and picture surface will drop simultaneously
when switch is pressed “down”. Door will close simultaneously
with picture surface as picture
surface rolls into case.
Figure 3
Cross Section
NOTE: If picture surface is hanging out of case approximately
12”, a wrap of the picture surface has been lost from around
the roller; see, “Restoring Roller Wrap”.
Access Panel
Screw (Painted)
Access Panel
Picture
Surface
Access
Panel Clip
Fabric Door
False Top