Da-Lite Professional Electrol - Manual (Page 3)

3
Picture Surface
1" x 3" Cleat
2" Moulding
Installation
Ceiling Mount
Without Hangers
Screen case is placed flush with
the wall and ceiling and held in
position by moulding securely
attached to the wall.
Recessed Above Ceiling
Other methods of installation
will suggest themselves in new
buildings where it would be an
easy matter to provide a recess
for the screen to conceal it when
not in use.
Do not seal in—allow access.
Wall or Ceiling Mount With Hangers
Wall type hangers and ceiling type hangers are
standard equipment. One set is supplied with
each screen. Useful for recessed installations.
Wall Type Hanger
NOTE: For Exposed Installation If the screen is to be mounted
in an exposed position, it may be covered with finished plywood,
veneer, paneling, plastic wall covering or a valance.
Suggested Methods of Installation
Picture
Surface
Picture
Surface
Ceiling Type Hanger
Picture
Surface
Rafters
Electrical
Outlet Box
5"
5" Reinforced
Top
Motor In The Roller
Screen Without Doors
Length = Fabric Width
+10", All Sizes
11 5⁄16"
9 1⁄2"
Screens Up to 18' Wide
Motor
End
Motor
End
Electrical
Outlet Box
5"
5"
10 3⁄4"
Reinforced
Top
Motor In The Roller
Screen Without Doors
Screens 20' and Wider
Length = Fabric Width
+10", All Sizes
12 9⁄16"