Da-Lite Professional Electrol - Manual (Page 4)

4
Hangers (If required)
1. See Figure 3 for hanger placement.
2. On screens equipped with an ironing board, make sure
hangers do not interfere with the ironing board brackets.
Installation
Figure 3
11 1 ⁄
2
"
11 1 ⁄
2
"
Screens 22' Wide And Under
Case Length ÷ 2
Case Length ÷ 2
11 1 ⁄
2
"
11 1 ⁄
2
"
Screens Over 22' Wide
(Case Length – 23") ÷ 3
(Case Length – 23") ÷ 3
(Case Length – 23") ÷ 3
3. Level unit lengthwise with a carpenter’s plum level.
CAUTION! Do Not completely seal in unit. Access room
must be allowed for motor repair or fabric replacement
ATTENTION! Ne fixez pas complètement l'unité. Un
espace doit être laissé pour pouvoir réparer le moteur
ou remplacer la toile..
4. Remove shipping brace by removing 2 hex head screws
(Fig. 4).
5. Remove wrapping paper and tape strips (Fig. 4).
CAUTION! Do not cut wrapping paper or tape with
knife or any sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le
ruban adhésif avec un couteau ou un outil tranchant.
Retirez à la main.
6. Install electrical hook up that applies to your unit. Make sure
to review your Electrical Installation Checklists and wiring
diagrams (included) for either 110 volt switch, 220/240 volt
switch, or DRC low voltage control.
7. Test installation by carefully running surface up and down
several times. Be prepared to stop screen.
NOTE: The picture surface, when rolled down, should have
at least a full wrap and a half around the roller. Do not allow
any part of the roller to become exposed.