Folding the picture surface for packing – Da-Lite Fast-Fold Deluxe Screen System User Manual

Page 4

Advertising
background image

4

Folding The Picture Surface For Packing

When folding the screen material for packing, observe the following precautions before proceeding:

1. The surface should not be allowed to contact painted,

varnished or plastic finished objects for a prolonged
period of time.

2. Make certain the picture surface is on a clean, flat surface.

Then proceed in the following manner:
Place clean white tissue paper – with no printing – on top of the

picture surface. If tissue is not available, a soft

white cloth or

something similar will serve the same purpose. Under no
conditions should newspaper or anything similar be used since
these may damage the screen material.

1. With the viewing side facing up, fold the fabric in half from

top to bottom. Make certain when folding, the surface does
not come in contact with either the black binding, grommets
or snap buttons.

2. If the material on the first fold is more than 3 feet

high, then fold once again, but always place clean tissue
paper between the folds.

3. For large size screens, fold in half again if necessary. Make

certain when folding, the surface does not come in contact
with either the black binding, grommets or snap buttons.

4. After the top to bottom folding procedure is completed, then

fold from left to right and continue folding until the fabric is of
sufficient size to fit into the leatherette case.

NOTE: Keep the screen surface in the envelope provided when it

is not in use. Failure to observe these normal precautions may
cause discoloration of the material.

Cleaning

Da-Mat®, Da-Tex®, High Contrast Da-Tex®, Pearlescent, Cinema

Vision, Dual Vision, Ultra Wide Angle and 3D Virtual Black™
surfaces can be cleaned as follows:

Using a white clean cloth (100% cotton preferred) that is

dampened with clear water, gently wipe the area in one
direction. Do not use a circular motion. Using a dry 100% cotton
cloth, wipe dry after each cleaning session. To clean a stubborn
stain or a sticky surface, use denatured alcohol (methanol or
methyl alcohol) following the same procedure as for water. For
extremely stubborn stains, use V M & P, Naphtha or Super
Naphtha and follow the same procedure as for water.

NOTE: Fast-Fold® screens are shipped with tissue paper packed

between the folds. This keeps the material from sticking to itself
and makes it easier to unfold.

Advertising