Da-Lite Curved Series 200 Lace and Grommet Frame - Manual (Page 2)

2
Frame Assembly
You will need a 9/16" wrench to assemble your Series 200/300 lace and grommet frame. If you have a split frame, you will also need a
3/16" allen wrench. Before beginning assembly make sure the work surface is clear of objects or debris that could scratch the frame or
puncture the viewing surface. Use the wrapping material to lay the frame sections on to keep from scratching the frame.
1. Unwrap the frame sections and orient them as shown in the
Figure below. Note that the ends are color coded. Make sure
the colors match at each corner. If your frame has the
optional Pro-Trim masked borders, lay the frame with the
borders facing down. Be sure to lay the frame on the
wrapping material to keep the Pro-Trim clean.
2. If your frame has two-piece top and bottom frame sections,
match the color codes on the ends of the tubes. See split
frame assembly on page 4. When top and bottom sections
are assembled the corners should lay flat to assure that
the unit does not twist or bow.
3. Slide the side frame sections onto the top frame section.
Insert one 3/8" bolt at each corner and tighten (do not
over-tighten).
4. The next step is much easier with two people. With one
person at each end, slide the bottom frame section into the
side frame sections. Make sure each side slides evenly to
avoid binding. Insert one 3/8" bolt at each corner and tighten
(do not over-tighten).
5. Frame assembly is complete. Next, unwrap the viewing
surface (sold separately) and lay it face down inside
the frame assembly.
6. The viewing side of the surface is wrapped to the inside
of the roll so you will have to unroll the surface and then
turn it over. Be sure to lay the surface on the wrapping
material to keep it clean.
7. Start at one side of the frame and locate the center of the
viewing surface and frame. The center of the screen surface
can be identified by a bright colored grommet on each of the
four sides. The center of the frame is marked by a piece of
colored tape. Starting at the center, begin attaching the hooks
on the frame into the grommets holes in the screen surface.
When you get to one end, the grommet in the corner of the
viewing surface should be attached to the s-hook in the
corner of the frame.
Installation
3/8" Bolt
4-Pieces
Figure 1