Da-Lite Curved Series 200 Lace and Grommet Frame - Manual (Page 4)

4
Hex Nut
Figure 3
Frame Clamp
3" Minimum
Upper Hanger
Bracket
Lower Hanger
Bracket
Series
300
Frame
Equals Outside Frame Height
• 4 3/4" With Pro-Trim Border
• 4 1/2" Without Pro-Trim Border
(Pro-Trim Border Adds 1/4"
To Frame Height
The Series 300 frame is supplied with eyebolts for ceiling installations and hanger brackets for wall mount installations.
Ceiling Installation: The frame is predrilled for the attachment
of the eyebolts. There are 3 eyebolts for smaller frames with a
one-piece top frame rail. Larger frames with two-piece top frame
rails will have 4 eyebolts. Insert the eyebolts through the frame
and attach the hex nut to the eyebolt.
Wall Mount Installation: There are 6 hanger brackets for
smaller frames with a one-piece top frame rail. 8 hanger brackets
are provided for larger frames with two-piece top frame rails.
Determine where the Series 300 frame will be mounted on the
wall. Consider the following before attaching the hanger brackets
to the wall.
• The hanger brackets must be anchored to a supported
section of the wall, such as a wall stud.
• The hanger brackets should be spaced on the wall so
they line up with the S-hooks on the frame. This will
prevent the lace cord from being pinched between the
frame and hanger.
• You will need at least 3" above the hanger bracket to
mount the Series 300 frame (see Figure 3).
• Frames with one-piece top frame rails should be
supported at the center of the frame and about 2-4 feet
from each end of the frame.
• Frames with two-piece top frame rails should be
supported about 2-3 feet on each side of the center joint
and about 2-4 feet from each end of the frame.
1. Attach 3 or 4 hanger brackets (as required above) at the
same height along the wall. To determine the distance
between the upper and lower hanger brackets you must
measure the overall height of the frame. If your frame has the
Pro-Trim border subtract 4-3/4" from the overall height. If your
frame does not have the Pro-Trim border subtract 4-1/2" from
the overall height. Using this number, measure down from
each hanger bracket and mark the wall.
2. Line up the lower hanger bracket with the mark and secure it
to the wall. Refer to Figure 3.
3. Remove the frame clamp from the hanger brackets and
position the Series 300 frame on the hanger brackets as
shown in Figure 3.
4. Place the frame clamp onto the hanger bracket and secure it
with the supplied hex nut.
Series 300 Installation