Da-Lite Imager - Manual (Page 3)

3
Tools Required:
Phillips Screwdriver
Carpenter’s Level
Tape Measure
Frame Assembly
1. Place the four frame pieces on a clean floor.
2. Slide the frame pieces together at corners. (Note: Frame
assembly holes may not appear to fit properly at the corners
until all fasteners have been attached. Once fasteners are
attached, the frame corners will be drawn in for a proper fit.)
Secure frame pieces with #10 screws provided. Do not tighten
screws until all are started, then tighten. See Figure 1.
3. Tighten the two screws at each corner. Do not over-tighten
the screws.
4. Insert and tighten the snap stud in the center of the corner
bracket (Figure 1).
Attach The Viewing Surface
Unroll the screen on a clean surface. Do not use newspaper.
The viewing side is rolled to the inside of the roll. Place the frame
over the screen surface, and while lifting the frame with one
hand, snap the screen surface onto the frame with the other
hand while maintaining a steady pull on the surface.
Method 1
1. Secure the large wall bracket to wall studs at the desired height.
Make sure the bracket is level. The top of the frame will be 1/8"
above the top of the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the screen.
Figures 2, 3, and 4 show the proper orientation for the supplied
wall brackets.
2. To install the small wall bracket, you must measure the overall
height of the screen frame and subtract 1-3/8". Using that
dimension, measure down from the top edge of the wall bracket
and mark the wall for two screw holes. The holes should be
centered within the frame and 6" apart. Refer to Figure 3.
3. Attach the small wall bracket to the wall. Refer to Figure 4 for
proper orientation. Do not tighten the screws completely. The
bracket should slide up and down easily.
4. Hang the screen on the brackets by hooking the bottom of the
frame onto the small wall bracket and lift up until you can hook
the top of the frame on the top large bracket. Push down on the
frame to seat it on the brackets. Refer to Figure 4.
Setting Up Your Screen
Method 1 (Screens 80" And Smaller In Viewing Width)
Figure 1
Figure 2
Small Wall Bracket
1-Piece
Large Wall
Bracket
1-Piece