Da-Lite Imager - Manual (Page 5)

5
1. Secure the large wall brackets to wall studs at the desired height.
Make sure the brackets are level. The top of the frame will be 1/8"
above the top of the large wall bracket when mounted. You will
need at least 5/8" clearance above the bracket to hang the
screen. Figures 6 and 7 show the proper orientation for the
supplied wall brackets.
2. To install the lower large wall bracket, you must measure the
overall height of the screen frame and subtract 1/4". This is the
dimension from the top of the upper large wall bracket to the
bottom of the lower large wall bracket. See Figure 6.
3. Position the screen with the attached surface onto the top large
wall bracket as shown in Figure 6. Push down at the center of the
bottom frame rail to hook onto the lower large wall bracket.
Method 3 (Screens Over 96"
In Viewing Width) Cleaning
Da-Tex®, Dual Vision, Pearlescent, Cinema Vision, Da-Mat®,
High Contrast Da-Mat®, Audio Vision, High Contrast Audio
Vision, High Contrast Cinema Vision and High Contrast
Cinema Perf surfaces can be cleaned as follows:
Using a white clean cloth (100% cotton preferred) that is
dampened with clear water, gently wipe the area in one direction.
Do not use a circular motion. Using a dry 100% cotton cloth,
wipe dry after each cleaning session. To clean a stubborn stain
or a sticky surface, use denatured alcohol (methanol or methyl
alcohol) following the same procedure as for water.
Figure 7
Large Wall
Brackets
3-Pieces