Da-Lite Multi Format Imager - Manual (Page 6)

6
9. Assemble top right and bottom right corner assembly by inserting (3) #10 x .375" long button head screws through bottom of frame
into the corner L connector bracket. Tighten two set screws on flat "L" bracket to line up the front faces as shown in Figure 12.
10. Route the two cable assemblies around motor bracket and plug the 3 wire male connector into the 3 wire female connector
on the motor bracket. The motor will have a gray data cable with an RJ-45 connector on the end coming out of the head of the
motor. Plug this end into the RJ-45 coupler. Tuck the RJ-45 coupler underneath motor bracket securely to prevent entanglement
as shown in Figure 13.
Multi Format Imager Assembly
Figure 12
Figure 13
Tighten Set Screws
Until Front Surfaces
Are Flush
Plug Motor
Power In
Data Cable
From Motor Head
Tuck RJ-45 Coupler
Underneath Motor
Bracket
Route Power
Cable Behind
Motor Bracket
Tuck Excess
Wire Underneath
Motor Bracket
Fasten Screws
Through Top Frame
Assembly Into
Connecting Bracket
Tighten Set Screws
Until Front Surfaces
Are Flush
Fasten Screws
Through Bottom Frame
Assembly Into
Connecting Bracket