Da-Lite Multi Format Imager - Manual (Page 7)

7
11. Untape black steel wire tension cable from bottom left side assembly. Un-wire tie the cable assembly. Run black steel wire tension
cable down around pulley at end and bring back towards the end. You may have to pull slightly hard and clip the tension cable to
the eyebolt secured in the slat bar as shown in Figure 14. Be careful not to pinch your fingers in the spring. Repeat this step for
bottom right corner of screen.
Multi Format Imager Assembly
Figure 14
Pinch Guard
Wrap Wire
Tension Cable
Around Pulley
Clip Wire Tension
Cable To Eyebolt