Da-Lite IDEA Interactive Cart - Manual (Page 2)

22516 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Da-Lite® is a registered trademark of Milestone AV
Technologies. All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located on the projector boom arm do not
exceed 25 lbs (11.34 kg).
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS--
eBeam™ Interactive System Requirements
The eBeam™ Interactive system works with standard
projectors and Windows® and Macintosh® computers.
IMPORTANT ! : After adding batteries to the stylus (FF),
tighten the cap only to the point of being fingertip-tight.
Overtightening cap may cause the stylus to stop
transmitting signals.
Minimum System Requirements
• Windows® System
• Compatible PC with Pentium™ II 400 MHz+
processor and 256 MB RAM
• Windows 2000, XP, Server 2003, Vista, or 7
• 30 MB available hard drive space
• Available USB port
• Macintosh® System
• Power PC®/Intel™ 1.42 GHz+ processor and 1G
RAM
• Mac OS X 10.5 through 10.6
• 25 MB available hard drive space
• Available USB port
Active Capture Area Size
• The maximum active capture area supported is:
4 ft x 7 ft or up to 94 inches diagonal measure.
• The minimum active capture area supported is:
1.7 ft x 1.1 ft.
Connection Requirement
• The interactive mount includes a USB cable.
Screen Recording Requirements
(Currently available only on Windows platform.)
• Pentium™ IV processor
• 1.4GHz, with 512MB RAM