Danby DWC040A2BDB - Manual (Page 12)

TROUBLESHOOTING
Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this troubleshoot-
ing guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s
Toll Free Number 1-800-263-2629 for assistance.
Problem Possible Cause What to do
No power A fuse in your home may be
blown or the circuit breaker
tipped.
Power surge.
Plug not fully inserted into wall
outlet.
Replace fuse or reset circuit
breaker.
Unplug the wine cooler, wait a few
seconds and then plug it back in
Make sure the 3-prong plug is fully
inserted into outlet.
Cabinet temperature too high Temperature setting.
Door not shut properly or opened
excessively.
Interior lights toggled on.
Recently added a large quantity of
warm bottles to the cabinet.
Verify the temperature control
setting. Adjust if neccessary.
Ensure that the door is fully closed
and that the gasket is sealing.
against the cabinets. Open the
doors only as needed and for short
periods of time.
The interior lights are intended for
temporary lighting of cabinets for
display purposes only. They are not
intended to be left on for prolonged
time periods.
Limit the quantity of warm bottles
being introduced to the cabinet at
the same time. Attempt to stagger
the load introduction if possible.
Condensation on the cabinet,
doors or fl oor High humidity conditions in the
home.
Door not shut properly or opened
excessively.
The condensation will subside once
humidity conditions return to nor-
mal.
Ensure that the door is fully closed
and that the gasket is sealing.
against the cabinets. Open the
door only as needed and for short
periods of time
9