Desa Wall Mantel with Base and Trim WS26CP - Manual (Page 3)

www.desatech.com 119792-01B 3
Figure 5 - placing mantel assembly onto mantel top
Top
Leg
Assembly
Figure 8 - assembling trim
ASSEMblING TRIM FOR GAS FIREPlAcES
1. Remove packaging from three pieces of trim.
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 8.
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 8).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 8).
6. While firmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screw-
driver.
7. Repeat steps 2 through 6 for other corner.
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot
Figure 7 - attaching mantel assembly to Base
Mantel
Base
Mantel
Assembly
8. Place mantel assembly onto mantel base and center left
to right with back of assembly flush with back of base
(see Figure 7). Use 1 1 /
4
" screws in pocket holes to attach
mantel assembly to mantel base. Using brackets and 1/2"
or 3/4" screws from this hardware kit (118983-01) attach
support brackets to base and mantel assembly - one at
each back corner of the leg sides and one on each leg
front (see Figure 7).
Figure 6 - adding Brackets to mantel top
1/2" or 3/4"
Screw
1 1 /
4
"
Screws
Bracket
1 1 /
4
"
Screws
1/2" or 3/4"
Screws
Bracket