Dillon Precision RF 100 - Manual (Page 4)

2. While pressing down on the plastic
tray with your index finger, slide the card-
board jacket off. Fig #5
3. Lift up the plastic tray. Fig #6
4. Press the blue button.
Now that your first tube is filled, go
ahead and fill the primer magazine on
your reloading machine, and replace the
filler tube. Repeat steps 1-4.
Begin reloading. While you are load-
ing your ammo, the primer filler is filling
the next tube.
Changing Primer Sizes
Changing Adapters
Using a 7/16” wrench, remove the
four bolts (#17894) that hold the clear
protective cover. Set the cover aside.
Next, using a 1/8” Allen wrench,
remove the adapter screw (#13964) and
then the colored, plastic adapter (#17285
large, #17286 small). Fig #7
In your change-over kit you will find a
colored filler tube, a plastic adapter, and
stabilizer plate (#17295 comes only with
the large kit). Fig #8
Tighten the adapter screw (#13964)
until it contacts the plastic feed adapter,
then back it off .040”, or the thickness of
a dime.
Fig. 8
Fig. 7
Fig. 5
Fig. 6
#13728
#17285, large (red)
#17286, small (blue)
#17902, large (red)
#17903, small (blue)
#14040
#17898
#17294 (small)
#17295 (large)
#13964
#17285 (large)
#17286 (small)
4
RF 100 Primer Filler, May 2007 5/22/07 9:35 AM Page 4