Ditch Witch FX25 - Manual (Page 75)

Service - 74
FX25 Operator’s Manual
10 Hour
CMW
Check Water Pump Belt Tension
Check belt every 10 hours for correct tension,
damage or wear. Contact your Ditch Witch dealer
for adjustment or belt replacement.
To check
1. Turn ignition to STOP and remove key.
2. Apply moderate thumb pressure to belt
between pulleys.
3. Belt is properly tensioned when deflection is
.125-.25” (3-6 mm).
Clean Vacuum Air Filter
Clean filter every 10 hours or as needed.
To clean filter:
1. Remove filter from canister.
2. Run low pressure water into inside of filter.
3. Allow filter to dry completely before returning to canister.
Breathing
crystalline silica dust may cause
lung disease. Cutting, drilling, or
working materials such as
concrete, sand, or rock
containing quartz may result in exposure to
silica dust. Use dust control methods or
appropriate breathing protection when
exposed to silica dust.
NOTICE: Do not use high pressure water to clean filter. Filter will be damaged.
4
2
j32om040h.eps j32om040h.eps
j32om015h.eps j32om015h.eps