EarthQuake 26750 - Manual (Page 8)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 8
Operator's Manual
VECTOR™ Compact Tiller
IMPORTANT
THE RIGHT AND LEFT SIDES OF YOUR RO-
TOTILLER ARE DETERMINED FROM THE
OPERATING POSITION AS YOU FACE THE
DIRECTION OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY WITH-
OUT OIL. YOU MUST ADD ENGINE OIL BE-
FORE STARTING ENGINE.
UNPACKING AND ASSEMBLY
UNPACKING AND ASSEMBLING YOUR TILLER
1. Open top of carton and remove handlebar assembly.
2. Parts bag for VECTOR tiller contains:
2- Bolts M8 x 1.25 x 20 Hex Head
6- Bolts M8 x 1.25 x 25 Hex Head
6- Washers M8 8.4mm x 24mm x 2.2mm
6- Nuts M8 x 1.25
2- Middle Handlebar Straps
2- Hand Knobs
6- Bolts M6 x 1.0 x 12
6- Nylock Nuts M6 x 1.0
3. Remove machine from carton
4. Assemble the upper handlebar onto the lower handlebar
loop. Use the two (2) middle handlebar straps to connect the
upper handlebar to the lower handlebar loop. Put the M8 x
25 bolts through the six lower bolt holes from the outside in.
Put on six (6) washers and tighten with six (6) M8 nuts on the
six (6) bolts. Tighten the two (2) M8 hand knobs on the two
(2) M8 x 20 bolts in the upper most hole on each side of the
handlebar. (SEE FIGURES 1 AND 2) The two (2) upper bolts
and hand knobs can be used in one of three hole positions
for handlebar height adjustability. SEE FIGURE 3
CAUTION
DO NOT TRY TO LIFT THE ROTOTILLER FROM THE
CARTON.
FIGURE 1
FIGURE 2
FIGURE 3
Highest Position
Lowest Position
Middle Position
M8 x 25 bolts
lower handlebar loop
M8 nuts
washers
upper handlebar
handlebar strap
lower
handlebar loop
M8 hand
knobs
M8 x 25 bolts
L R
M8 x 20 bolts