Echelon DM-21 Device Manager - Manual (Page 58)

5-6 Installing and Getting Started with the Device Manager Software
10. Click Next. The window shown in figure 5.4 will appear.
Figure 5.4 – Select Subsystems
Select which subsystems are used to create the managed device list. For this
simple network only one subsystem is listed in the left pane. In a more
complex network the left pane is used to navigate the subsystem hierarchy to
select the subsystems to be loaded.
11. Highlight the existing subsystem, and click Add.
The subsystem will be copied to the right pane indicating that it has been
selected for compression and load. This first subsystem is assigned a PIN
value of 0; setting the Device Manager’s 4-bit subsystem selection input to
zero at runtime selects this subsystem.
When the Device Manager is loaded with only a single subsystem it is not
necessary to supply a 4-bit input. By default, the Device Manager's
DM_Pin_Usage
configuration property is set to Use Subsystem Zero which
causes the Device Manager to select the first subsystem in its managed
device list.