Elenco Mini Electric Guitar - Manual (Page 6)

7 to 10 mm
CAUTION
Make sure that 7 to 10mm
of the tuning shaft sticking
out.
Assembling
The Body
Assemble the tuning unit
Tuning
shafts
Protrusion
If the tuning shaft
cannot be inserted
properly, try
pressing the shaft in
while rocking it left
and right.
Make adjustments so that
the wings of the knob are
the same height as the
tuning shaft.
1. Attach the tuning shafts to the body
Face the side with the square protrusion up and insert the
tuning shafts firmly from the outside.
2. Attach the tuning peg knobs
Attach the tuning peg nuts to the
tuning peg knobs. Then attach them to
the tuning shafts by turning the knob.
Tuning peg nut
Tuning peg knob
Wings of the knob
Tuning shaft
(a)
Attach the neck 2
Turn the neck and body over and attach the body to the neck
from above. Fasten the neck side (a) only with a bolt and nut.
At this point, there is no need to tighten the bolt and nut
firmly.
Bolt
Nut
Although it may protrude slightly
from the body, this is not a problem.
3
1. Temporarily insert the washer head screws
into the back of the neck.
Leave about 2mm of the head protruding
Attach the strings
Temporarily
insert the
washer head
screws
String anchor shaft
Thick
Thin
2. Slide the strings onto the string anchor shaft
Unwind the strings leaving the piece of paper bundling
them. Once you have unwound the strings, remove the
paper. Slide the rings on the tips of the strings onto the
shaft to attach the strings in order of thickness.
Take caution not to injure hands or face with the tips of the strings.
1
CAUTION
CAUTION
6 JR.SCIENTIST