Elenco Mini Electric Guitar - Manual (Page 8)

1. Attach the volume dial
Align the volume dial hole and place the volume dial onto
the volume dial protrusion on the circuit board and fasten it
to the circuit board with the screw (small).
Volume dial
Circuit board
Circuit board volume
2. Attach the speaker to the body cover
Secure the speaker with washer head screws.
The speaker may become tilted if the screw is
overtightened. Do not secure the speaker while it is
tilted. If this happens, loosen the washer head screw
half a turn.
Speaker
Washer head screws
It becomes easier to secure the
speaker if the washer head
screws have been passed
through the screw holes on the
rubber part of the speaker
beforehand.
The side with the transparent
cone should face up. Try not to
touch the cone.
Body cover
3. Connect the power connector
Plug in the power connector to the circuit
board. (Plug it in firmly.)
Power connector
*Note the direction of the connector
Screw (small)
Pickup bottom plate
Pickup top plate
Pull about 5 cm of the coil wire
through.
1. Combine the top and bottom plates of the pickup
Press the top and bottom plates of the pickup together
until they click into place.
2. Pass the coil wire through the hole in the pickup
bottom plate
Pass the coil wire through the pickup bottom plate. At
this point, pull about 5cm of the coil wire through and
affix it with cellophane tape.
4. Mount the circuit board
Adjust the position of the circuit board so that the volume
dial and the LED power indicator protrude from the holes
in the side of the body cover. Secure the circuit board
with the screw (Large).
Circuit board
Screw (Large)
Body cover CAUTION
Assemble the electrical components 4
Assemble the pickup 5
8 JR.SCIENTIST