Eurocom X8 User Manual
Page 191
Modules
Setting Up SATA RAID or AHCI Mode 7 - 5
7
Note that the following setup procedure is for clean systems only (i.e. the system has
not been previously setup in IDE/AHCI modes and is being changed to a RAID sys-
tem). If you are changing your system to RAID after having previously setup in an-
other mode see
“Changing The SATA Mode” on page 8 - 16
.
1. Go to the operable computer and insert a USB Flash drive or external USB HDD.
2. Insert the Device Drivers & Utilities + User’s Manual disc into the CD/DVD drive
of the operable computer.
3. Copy the f6flpy-x64 folder from the location below (D: denotes your DVD drive) on
the Device Drivers & Utilities + User’s Manual disc to the USB flash drive or
external USB hard disk.
• Windows 8.1 64bit = D:\Options\00_IRST\f6flpy\f6flpy-x64
4. Start-up your notebook computer and press <F2> to enter the BIOS.
5. Go to the Boot menu, select UEFI Setting and press <Enter> (see page
6. Set UEFI Boot to “Enabled”.
7. Press <Esc> to exit the menu and go to the Advanced menu.
), press <Enter> and select “RAID Mode”.
9. Press <F4> and <Yes> to “Save Changes and Reset”.
10. After computer restarts press <F2> to enter the BIOS again.
11. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press
<Enter>.
12. Select Create RAID Volume and press <Enter>.
Figure 7 - 1
Create RAID Volume
(Advanced > Intel(R)
Rapid Storage
Technology