Eurocom X8 - Manual (Page 287)

Troubleshooting
Problems and Possible Solutions 8 - 17
8
Changing the System from AHCI Mode to RAID Mode
1. Go to the operable computer and insert a USB Flash drive or external USB HDD.
2. Insert the Device Drivers & Utilities + User’s Manual disc into the CD/DVD drive of the operable computer.
3. Copy the f6flpy-x64 folder from the location below (D: denotes your DVD drive) on the Device Drivers &
Utilities + User’s Manual
disc to the USB flash drive or external USB hard disk.
• Windows 8.1 64bit = D:\Options\00_IRST\f6flpy\f6flpy-x64
4. Start-up your notebook computer and press <F2> to enter the BIOS.
5. Go to the Boot menu, select UEFI Setting and press <Enter> (see page
5 - 17
).
6. Set UEFI Boot to “Enabled”.
7. Press <Esc> to exit the menu and go to the Advanced menu.
8. Select SATA Mode (see page
5 - 10
), press <Enter> and select “RAID Mode”.
9. You will then receive the warning message (see
Figure 8 - 2 on page 8 - 16
) that changing the SATA mode will
result in needing to reinstall the operating system; press OK to confirm the change.
10. Press <F4> and <Yes> to “Save Changes and Reset”.
11. After computer restarts press <F2> to enter the BIOS again.
12. Go to Intel(R) Rapid Storage Technology (in the Advanced menu) and press <Enter>.
13. Select Create RAID Volume and press <Enter>.
Figure 8 - 3 - Create RAID Volume (Advanced > Intel(R) Rapid Storage Technology