Eurocom M570TU Montebello - Manual (Page 84)

BIOS Utilities
5 - 8 Advanced Menu
5
Advanced Menu
Installed O/S (Advanced Menu)
This setting tells the computer what kind of operating system you’re using. Make
sure you choose the correct setting for your O/S in order to prevent system problems.
Note: If you select the Vista O/S then the SATA Mode Selection menu will become
available. If you are installing the Windows XP O/S make sure you have set the ap-
propriate operating system here in order to prevent system problems.
Figure 5 - 3
Advanced Menu

SATA Mode & eSata
Port
The eSATA port only
supports hot-swapping if
you have selected AHCI
mode in SATA Mode
Selection.
If you have selected IDE
mode, then hot-swap-
ping devices connected
to the eSATA port is not
supported.
Main Advanced Security Boot Exit
F1 Help Select Item -/+ Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Select the operating
system installed
on your system which
you will use most
commonly.
Note: An incorrect
setting can cause
some operating
systems to display
unexpected behavior.
Advanced
Phoenix SecureCore(tm) Setup Utility
Installed O/S: [ Vista ]
SATA Mode Selection: [AHCI]
Legacy USB Support: [Enabled]
Boot-time Diagnostic Screen: [Disabled]
Legacy OS Boot: [Disabled]
Reset Configuration Data: [No]
Battery Low Alarm Beep: [Disabled]
Only available if Windows Vista
is selected as the O/S.