Eurocom M980NU XCaliber - Manual (Page 121)

Modules
RAID Setup 7 - 3
7
RAID Setup
You may use your hard disks (if you have included more than one hard disk in your
purchase option) in combination with Striping (RAID 0) or Mirroring (RAID 1)
or for either fault tolerance or performance (see
Table 7 - 1, on page 7 - 4 ). To con-
figure your system in Striping (RAID 0) or Mirroring (RAID 1) modes you will re-
quire at least two hard disks.

RAID Enable/Disable
Warning
DO NOT Enable/Disable
the RAID in SATA Mode
Selection in the BIOS un-
less you intend to reinstall
your operating system.
Make sure you have backed
up all your data before doing
so.
Note that if you do not wish
to use the RAID configura-
tion go to the Advanced >
Advanced Chipset Control
menu and set the SATA
Mode Selection item to
AHCI (see
Figure 5 - 3 on
page 5 - 8 ) before install-
ing the operating system.