Eurocom Panther 5D - Manual (Page 39)

33
Engl
ish
Troubleshooting
Problem Possible Cause - Solution
The Wireless LAN/Bluetooth
modules cannot be detected. The modules are off. Check the appropriate touch sensor indicator to see if the modules are on or
off (see
"Touch Sensor Instant Keys" on page 8 ). If the LED indicator is not illuminated, then
press the appropriate touch sensor instant key/function key combination in order to enable the
modules.
The Bluetooth module is off
after resuming from Sleep. The Bluetooth module’s default state will be off after resuming from the Sleep power-saving state.
Use the key combination (Fn + F12) or touch sensor instant key
to power on the Bluetooth
module after the computer resumes from Sleep.
The captured video files from
the PC Camera are taking up
too much disk space. Note that capturing high resolution video files requires a substantial amount of disk space for each
file. See
"Reducing Video File Size" on page 26 .
No sound can be heard
through an HDMI connected
display device. You have not configured the HDMI audio output. See "Audio Setup for HDMI" on page 20 .
I have installed the Windows
7 operating system but cannot
hear any sound. The audio driver is not installed. Install all the drivers as instructed in the section "Driver
Installation" and make sure you install the audio driver.
The computer is off (or in
Sleep Mode) but powered by
the AC/DC adapter plugged in
to a working outlet or powered
by the battery with a capacity
level above 20%. I have
plugged a device into the
powered USB port in order to
charge it, but the device is not
charging. The port is not powered on. Toggle power to the port using the Fn + power button combination.
This function may not work with certain external USB compliant devices (check your device’s
documentation). If this is the case, power the computer on and connect the external USB
device in order to charge it.