EXFO AXS-100 Series OTDR - Manual (Page 48)

Testing Fibers
40 AXS-100 Series
Testing in Auto Mode
4. Use the left/right function arrows until you see Parameters, and then
display the pane (F1/F2 key).
5. Select the test mode as follows:
5a. Use the arrows to select the OTDR
mode list, and then press Enter to open
the list.
5b. Use the up/down arrows to select Auto,
and then press Enter to confirm.
6. Select test wavelengths as follows:
6a. If your OTDR supports singlemode, singlemode live, or multimode
wavelengths, under Wavelength, from the list, select the desired
fiber type (for live-fiber testing, select SM Live; for C fiber, select
50 μm and for D fiber, select 62.5 μm).
6b. Use the arrows to select the desired wavelengths and press Enter
to confirm each selection.
7. Select duration of the acquisition as follows:
7a. Use the arrows to select the Duration list, and then press Enter to
open it.
7b. Use the up/down arrows to select the desired duration for the
acquisition, and then press Enter to confirm.