Desa CGEFP33PR EN - Manual (Page 24)

108117-01G
For more information, visit www.desatech.com For more information, visit www.desatech.com
24
INSTALLING BATTERY INTO REMOTE
1. Locate slot at bottom of remote control (see Figure 53). Firmly
insert tool such as a small screwdriver, butter knife, or dime
into the slot and lift up to remove cover.
2. Insert supplied battery into remote control. Positive and nega-
tive are marked inside remote control casing.
Note: Remote
will not function if battery is not installed correctly.
3. Slide tab on cover into remote housing and snap cover back
into place.
IMPORTANT: Use only A23 12 volt battery in remote. DO NOT
use AAA battery.
Positive
Figure 53 - Installing Battery
Negative
Tab
Cover
Remote
Control
Slot
INSTALLATION
Installing Battery Into Remote
Installing Screen
OPERATING FIREPLACE
For Your Safety Read Before Lighting
INSTALLATION
Continued
A23 12
Volt
Battery
Figure 54 - Installing Fireplace Screen (EFP33PR Shown)
INSTALLING SCREEN
Install fireplace screen by slipping notches of fireplace screen over
screws on front of fireplace (see Figure 54).
Notches
Screws for
Mounting Screen
OPERATING FIREPLACE
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which lights automatically when
using the supplied wall switch or remote control. If you
have a power outage, the pilot may be lighted by hand with
push-button piezo ignitor. When lighting the pilot, the fol-
lowing warnings must be followed.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Electric Power Outage Only: Use only your hand to turn
the manual override handle on the gas control knob. Never
use tools. If the knob will not turn by hand, don’t try to
repair it, call a qualified service technician or gas supplier.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.