EZ-ACCESS TRANSITION ANGLED ENTRY MAT User Manual

Instructions transitions, Angled entry mat, Fig. 1 fig. 2

Advertising
background image

Instructions

TRANSITIONS

®

Angled Entry Mat

Available in 1½” and 2½” heights


10273 12-15-14

CE Technical Files kept at: Enable Access, Marshmoor Works Great North Road, North Mymms Hatfield, AL9 5SD, UK

© Homecare Products, Inc. All rights reserved.

All text and images contained in this document are proprietary and may not be shared, modified, distributed, reproduced, or

reused without the express written permission of EZ-ACCESS

®

.

IMPORTANT INFORMATION

Rated load is 850 pounds. Never exceed rated load.
Read and follow all labels, instructions, safety and

maintenance information before use.

For additional care, use or safety information, or to obtain

replacement copies, please call 1-800-451-1903 or visit
www.ezaccess.com.

Do not use if ramp is damaged or unstable.
For wheelchairs and scooters only (not intended for

commercial use).

Ramp may be slippery when wet or icy.
Use only if sufficient maneuvering room is available at both

ends of the ramp to assure safe travel when entering and
exiting the ramp.

Use ramp only with a qualified helper and always use your

lap belt.

It is important that you refer to your equipment's (wheelchair

or scooter) User Guide for the proper degree of incline or
decline and chair direction before attempting ramp use.
Never exceed its recommendations.

FITTING AN ANGLED ENTRY MAT

1.

Mat can be easily trimmed to accommodate lower
heights and narrower widths and, if necessary,
notched to suit the doorjamb configuration.

2.

If door threshold is equal to the height of the mat,
use Angled Entry Mat as is.

3.

If door threshold is less than the height of the mat,
trim mat to the desired height as shown in FIG. 1
(serrations in the bottom of the mat can be used
as a guide).

Use caution when operating any non-manual
saw as serious injury may result due to
unexpected binding or pinching of rubber mat
material. Always follow tool manufacturer’s
safety guidelines.

FASTENING THE MAT TO THE LANDING
It is recommended that the mat be securely fastened.

1.

ATTACHING TO WOOD

a. Place mat in desired location and

ensure that surface is free of dirt and
debris.

b. Fasten mat using supplied Phillips head

screws (two each). Space screws
evenly (see FIG. 2 for placement) and
drive until head is ¼” below the mat
surface.

2.

ATTACHING TO CONCRETE

a. Place mat in desired location and

ensure that surface is free of dirt and
debris.

b.

Using a ¼” diameter masonry bit, drill a
hole 2” deep 1” from the edges of the
corners at the taper as shown in FIG. 2.

Ensure the holes are free of any
residue.

c.

Drive the supplied ¼” diameter
mushroom head pin anchors (two each)
into the holes with a hammer until the
head is seated.

SAFETY AND MAINTENANCE

1.

At all times, keep mat clear of snow, ice,
dirt, leaves, and other debris that may
accumulate on the surface.

2.

Clean mat with mild soap and warm water.
Rinse well and use extra caution when mat
surface is wet.

WARRANTY

Three-year limited warranty. See reverse side of
document for details.

FIG. 1

FIG. 2

Advertising