FeiYu Tech FY-Panda2 Autopilot - Manual (Page 47)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [email protected]
Page 45
( 5 ) S witch ―SW2‖ to ―NULL‖ and switch ―SW1‖to ―Manual mode‖. Use your RC sticks to control
the aircraft servos surface to see the movement is right or not.
( 6 ) To Check the servo control surface automatic movement and setting install direction, also
the airspeed and altimeter, First, you should switch"SW2" to "NULL" mode, then switch "SW1" to the "
Stabilized Mode ".
Taking the Aircraft roll tilt and pitch tilt, and checking whether the GCS attitude table shows the
attitude is correct or not if not, you need to re-set the" Inst Setting " .
Airspeed indicator and altimeter display value should be 0 or near 0 .Taking the Aircraft roll tilt,
pitch, tilt, and head deflection, and check whether the servo control surface automatic movement is
correct or not, the inspection method, please refer to the description of" Servo Control Reverse
setting".
Attention: If you normal connect the airspeed sensor to Panda
Ⅱ,the speed table(picture
below ) will display the airspeed. And if you do not use the airspeed sensor(Only connect the
GPS to pabda2),then will display GPS speed.
( 7 ) Data checking and vibration testing:
First check every flight control data is right or not.
Pushing the throttle ,and check whether the value of the " AHRS ERROR " is increase at each
throttle part. The normal situation is at the value of 0, if the values continue to increase, it shows that
you need to do more damping installation for PandaⅡ module. If you do not do well job for damping
installation, the aircraft can not take off.