FeiYu Tech FY-21AP - Manual (Page 5)

GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected]
GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected] page 5
FY-21AP INSTALLATION GUIDE
Equipments list:
 FY-21AP;
 FYOSD;
 FY-CS100A;
 FUTABA remote controller;
 FUTABA10 receiver;
 video transmitter;
 A pair of scissors,
 A knife;
 Double sided tape;
 Battery;
 Aircraft;
 Some related wirings.
1. Prepare the plane, install the electrical motor, servo,
etc.
2. Aircraft installation tools may include (but not
limited to) screwdriver, scissors, knife, foam
double-sided tape, Velcro with double sided tape,
etc
3. You should be able to do some basic wire soldering
to install the FY-CS100A (main battery current
sensor).
Connection wires include FYOSD plug, connecting
wires for camera and video transmitter to FYOSD,
the data wires between FYOSD to the FY-21AP and
the connecting wires from FYOSD to the RC
receiver.
4. FYOSD connection to camera and Video
Transmitter.
5. We recommend making a hatch door for FY-21AP
installation:
6. Connect the extension wire of the video transmitter. Install video transmitter to fuselage.
7. Connecting wires for FYOSD.
8. Use the Velcro tape to install FYOSD to the aircraft cabin.
9. Connect the RC receiver to the FY-21AP.
10. Connect the servos to the FY-21AP.
11. Power ON and check the connecting wires. Move the control sticks and check for correct
rudder, aileron and elevator movement.
12. Set CH5 and CH6 to a 3-position switch to control the three Flight Modes and Autopilot
Modes of the FY-21AP. Set CH7 to VrC, to control the data overlay of the FYOSD.
13. Adjust the three dial knobs. Turn all in one direction.ON your transmitter and connect power
to your plane. Switch the FY-21AP to Flight Mode 2: Stabilized Mode:
i. Check the automatic movement direction of each servo.
ii. Reverse dial knob rotation if servo movement is incorrect.
14. Connect the data wirings from GPS Module and FYOSD to the FY-21AP. Velcro tape the RC
receiver to the FY-21AP. Velcro tape the FY-21AP to the vibration absorbing mount.
15. Use double sided tape to fix the vibration absorbing mount to the plane‟s center of gravity.
16. Install Current sensor between the ESC and battery:
17. Fix the camera and GPS module:
18. Arrange the wires neatly inside the aircraft cabin (avoid the GPS Module). Installation is complete.
Go fly!
Note: FeiYu Tech reserves the right to change this manual at any time.
—— END ——
Note: We reserve the right to change this manual at any time! And the
newest edition will be shown on our website www.feiyudz.cn.
Incline FY-21AP to the right, left aileron goes up: Incline FY-21AP to the left, right aileron goes up: