Electronic digital clock, Clock setting procedure – Dodge 2009 Ram Chassis Cab User Manual

Page 174

Advertising
background image

26. Low Fuel Light

This light illuminates when the pointer is between
“E” and 1/8 indication mark (approximately 15%
of tank volume) on the fuel gauge. When the fuel

gauge pointer is on “E” (equivalent to Distance To Empty
[DTE] = 0 on the overhead console, if so equipped) there
is reserve fuel capacity, which corresponds to approxi-
mately 8% of tank volume. This reserve capacity was put
in place to prevent the likelihood of customers running
out of fuel when operating at maximum load conditions
in areas where there aren’t many fuel stations.

Fuel tank volumes are as follows:

• 52 gal (197 L) - Standard Rear Tank
• 22 gal (83 L) - Optional Mid Ship Tank

27. CRUISE Indicator

This indicator lights when the electronic speed
control system is turned on.

ELECTRONIC DIGITAL CLOCK
The clock and radio each use the display panel built into
the radio. A digital readout shows the frequency and/or
time in hours and minutes (depending on your radio
model) whenever the ignition switch is in the ON or ACC
position.

When the ignition switch is in the OFF position, or when
the radio frequency is being displayed, time keeping is
accurately maintained.

On the RAQ radio the time button alternates the location
of the time and frequency on the display. On the REF only
one of the two, time or frequency, is displayed at a time.

Clock Setting Procedure

1. Press and hold the time button until the hours blink.

2. Adjust the hours by turning the right side Tune/
Audio control.

172

UNDERSTANDING YOUR INSTRUMENT PANEL

Advertising