Glow-worm Heartbeat 4 - Manual (Page 15)

15 221905B
7 Final Review
Please ensure the “Benchmark” logbook (supplied with the
Back Boiler Unit) is completed and left with the user.
Check the operation of the fire at all control positions.
Visually inspect the appliance. Clean off any marks incurred
during installation.
Advise the customer how to operate the fire.
Explain to the customer that the appliance has a flame failure
and spillage monitoring system. Point out the explanation of this
system shown in the "Instructions for Use".
Advise that if the fire goes out for any reason, wait at least three
minutes before relighting.
Stress that if the monitoring system repeatedly shuts off the fire
or boiler, the appliance should be switched off and a specialist
should be consulted.
Advise the user that the window may require cleaning periodically
outside and inside as described in the users instructions.
Explain how to remove and replace the window unit for cleaning
the inside of the glass etc. Point out that a tool is supplied for
releasing the window screws. Leave the tool in the instruction
pack.
Advise that the fire may give off a slight odour while new. This
is quite normal and it will disappear after a short period of use.
Advise that any cleaning must only be carried out when the fire
is off and cold.
Advise the customer that they should read the Instructions
forUse before operating the fire and always follow the advice in
the section headed “Cleaning your fire”.
Advise the customer that the appliance will operate to its
maximum potential if the flue is primed during the first 20 - 30
minutes of use. To do this, simply turn the control to its highest
setting. This will also burn off any carbon deposits that may
have formed during previous use.
If using the appliance for long periods it is beneficial to change
between settings. This will also help to remove any carbon
deposits that may form during use.
Recommend that the appliance should be serviced and the
chimney inspected by a competent person (In the UK a CORGI
registered person) at least annually.
If the appliance is in premises in the United Kingdom occupied
by a tenant, point out that by law a landlord must have any gas
appliance, flue and pipework which is situated in a tenant’s
premises checked for safety at least every 12 months.
Reminder - leave these instructions and the “Benchmark”
logbook with the user.