GoDEX DT series - Manual (Page 30)

26
DT2 / DT4 series User Manual
5. Accessories
5-1. Installing the label dispenser
1 Label dispenser
2 Screws (set of 2)
【 Note1 】 Remember to
switch off the printer before
installing the label dispenser.
【 Note 2 】 A label liner
thickness of 0.006 mm ± 10%
and a weight of 65 g/m 2 ±
6% are recommended.
【 Note3 】 The label dispenser
will take labels up to a max.
width of 110 mm (DT4) or 54
mm (DT2).
1. Place the printer on a
flat surface and open
the printer cover.
2. Remove the front cover.
【 Note 】
You can use a coin or
screwdriver to open the
cover.
3. Pass the dispenser cable
through the opening as
shown in the illustration.
4. Fit the label dispenser in
the recess provided.
2
1