Grandview GPCK-MA - Manual (Page 10)

9 8
L
N
E
M
POWER HDMI VIDEO VGA
CENTRAL CONTROL
UP
STO P
DOWN
Wall-Switch Function
Please follow the signs and symbols on the wall-switch
Cable Box
Brown line
Blue Line or Black Line
Yellow and Green Line
Circuit
Board
Socket
Blue Line
Brown line
Black Line
Yellow and Green Line
Connect Point of Ground
figure 9
7. Cut the ceiling board(Step 1)to a suitable size,which can maintain the gap after retracting of the projector lift
figure 10
8. Please read the《Remote Electric Positioning》for controlling the projector lift. After the adjustment,
ensure the height of projector lift can satisfy your requirement after extending. And then, ensure the bottom of
projector lift must align to the ceiling afer retracting. Note: the operating must be controlled by processional
people.
Instruction
Front view
Button instruction for controller
1. Press "UP" ,projector goes up
2. Press "STOP" ,projector stops
3. Press "DOWN" ,projector goes down
1.Remote controller instruction
Remote controller guideline:
1. Work temperature: -20°to 70°
2. Batteries: 1.5V x 2pcs, model: AAA.
3. Take out batteries if the controller will not be used for
a long time.
4. Please change the batteries when signal is weak.
Back view
Sling wires localizer
Installation for controller batteries
Please replace the batteries when the signal of controller
is weak
1. Push out the battery cover on the back of controller
2. Install the batteries as guide arrow
3. Reinstall the battery cover
Caution
Install the batteries correctly
Red LED
Wall-Switch
(6p6c)
Cable(8PIN)
UP
STO P
DOWN Electricity
AC: 230 v 50Hz
170W (0.7A)