Grandview Wireless Synchro Converter(RF to IR) - Manual

1 2
Model 868M-IR
Interface 3.5 Double-Channel Input
Frequency 868MHz
Demodulation FM
3
Instructions Manual For
Wireless Synchro Converter ( RF to IR )
Description
Wireless Synchro Converter (RF to IR) Receiver Head
Usage
1. Connect power to the screen (figure 1), and then the
indicator light stays on that Wireless Synchro Converter is
ready for using.
Figure 1
Indicator Light
Indicator Light
Figure 2
2. Please run the programming process firstly if this is the first
time for using this product.
Method: press the signal programming button via a small pin
(figure 2). Press the signal programming button, and then the
indicator light will flesh repeatedly (this process will finish after
60 seconds). After the emitter sends out the project of
programming
the indicator light will stop flashing and stay on.
Converter Unit
3.5 Stereo Input IR Receiver
Indicator Light
Signal Programming
Output
Wireless Synchro Converter
This product can only be used in Grandview Integrated Motorized Screen with EXT CTRL input .
Synchro Power Relay
Ceiling
Projector Ceriling Mount
Fixation Belt
Projector
Guangzhou Grandview Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shatou, Panyu District, Guangzhou, Guangdong, China
Tel: +8620-8489-9499 Fax: +8620-8480-3343
Website: www.grandviewscreen.com
Grandview Crystal Screen Canada Ltd.
#11- 3751 North Fraser Way, Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: 1-604-412-9777 Fax: 1-604-412-9796
Website: www.grandviewscreen.ca
Clear memory: press the signal programming button for 5 seconds, and then the
indicator light will flesh repeatedly. At the same time, release the button then press
this button again for clearing the memory.