Hall Research URA-XT - Manual (Page 12)

Model URA, URA-SKU, & URA-XT
10
3.3 Advanced Adjustment
The URA series of devices can equalize the brightness of the
video by reducing smearing.
 Apply power to the receiver. Wait until all LED’s are
turned off
 Press the SEL button once to enter Adjustment-mode.
 In
Adjustment-mode , all three (3) LEDs will be ON solid.
 Press and hold the SEL button for at least 3 seconds to
enable the Video Brightness Adjustment Mode
(previously called Wire Gauge Mode).
 In
Video Brightness Adjustment Mode , the GREEN
and BLUE LED’s will be blinking.
 The ▲ button raises the video brightness level.
 The ▼ button lowers the video brightness level.
 Pressing BOTH the ▲/▼ buttons at the same time will
reset the Video Brightness to the default setting.
 While using the ▲/▼ buttons, if an upper or lower limit of
the adjustment is reached, the LED’s will blink for each
continued press of the ▲/▼ button.
 To exit the Video Brightness Adjustment mode at any
time, press the SEL button until all LED’s are ON solid.
Press the SEL button once more until all LED’s are OFF
(The unit also has a built-in 1 minute timeout).
Note
The Video Brightness adjustment may not be noticeable
when only using 1 device. When products are daisy-chained,
using the URA-XT the adjustment is easier to observe.