Hall Research VSM-I-A-16-16 - Manual (Page 29)

27
Genesis™ Matrix Switches
3.2.2.2 To make an audio tie:
Command:
CAn,m<cr> stands for Connect Audio n = output, m= input
Note: Unit accepts leading zeros in the numbers. Spaces are ignored. To check the
source of a particular output, omit the input channel and just enter CAn<cr>.
Response:
CAn,m<cr>
3.2.2.3 To make a synchronized audio/video tie:
Command:
COn,m<cr> stands for Connect Output n = output, m= input
Note: Unit accepts leading zeros in the numbers. Spaces are ignored. To check the
source of a particular output, omit the input channel and just enter COn<cr>.
Response:
CAn,m<cr>
CVn,m<cr>
Note: If the system does not have audio, it will still accept this command but
response will be missing audio tie line.
3.2.3 Preset Pattern Saving and Routing Functions
3.2.3.1 To recall a saved preset Video routing pattern:
Command:
PRx<cr> stands for Preset Recall. x = preset # can be 1 to 16
Response:
PRx<cr>
CVn
1
,m
1
<cr>
CVn
2
,m
2
<cr>
3.2.3.2 To save the current Audio & Video routing pattern to a preset:
Command:
PSx<cr> stands for Preset Save, x = preset # can be 1 to 16
Response:
PSx<cr>
3.2.4 Restoring Factory Defaults
To restore factory defaults:
Command:
FR<cr> stands for Factory Restore
Response:
Are you sure (Y,N)?<cr>
Note: You have 5 seconds to press Y, or the command is cancelled.
Factory defaults restored<cr> if the “Y” was entered.
Cancelled<cr> if other key was entered or command times out.