Hall Research VSM-I-A-16-16 - Manual (Page 38)

36
Hall Research Technologies, Inc.
OK .................................................. if command completed successfully.
Error........................................................................... if command failed.
6.
To get the current subnet mask:
Command:
GNM <cr> stands for Get Net Mask.
Response:
255.255.255.0
7.
To set a subnet mask:
Command:
SNM255.255.255.0 <cr> stands for Set Net Mask.
Response:
OK .................................................. if command completed successfully.
Error........................................................................... if command failed.
8.
To get the current port number (this is the port to access the matrix):
Command:
GPN <cr> stands for Get Port Number.
Response:
1001
9.
To set a port number (IP port that controls the Matrix):
Command:
SPN1000 <cr> stands for Set Port Number.
Response:
OK .................................................. if command completed successfully.
Error........................................................................... if command failed.
10.
To get a device/host name:
Command:
GDN <cr> stands for Get Device Name.
Response:
xxxxxxxxxx
Note on Device Name
This is the host name assigned to the IP port; it is independent of the
name assigned to the matrix (NU command), though you can use the
same name if you wish!
11.
To set a device name:
Command:
SDNnew_name <cr> stands for Set Device Name.
Response:
OK .................................................. if command completed successfully.
Error........................................................................... if command failed.
12.
To reboot the system for the changes to take effect: