2 configuration files – Hall Research CNT-IP-2 User Manual

Page 7

Advertising
background image

CNT-IP-2

7

4.1.3 Assign Static IP address using web Interface

Follow these steps to configure the CNT-IP-2 IP address.
•

Open a browser window and enter the IP address indicated by Device

Finder Software.

•

When prompted, Login with username: admin and password: pass

(both lowercase).

•

Click on each of the Configuration  System  Communications tabs.

•

From this screen, the unit can be set for a DHCP or static IP address. It

is usually best to assign a static IP so the CNT-IP-2 browser address will

always remain the same between power cycles.

•

Set the IP address to a known reserved IP dedicated on your network for

this CNT-IP-2 device. Contact your network administrator if needed.

•

Set subnet mask to 255.255.255.0 (change appropriately if multiple

subnets are being used). Contact your network administrator if needed.

•

Set the gateway. This is usually XXX.XXX.XXX.1 where the first three

octets match the subnet. ( Consult your network administrator if

necessary).

•

Set the DNS server. If you don’t know this information you can usually

specify the gateway address for the primary DNS. The Secondary DNS

address is optional.

•

Click the SAVE Icon in the upper right corner of the Tab.

•

Click on each of the Configuration  System  Basic tabs. Click the

reboot button. It should take approximately 15 seconds for the unit to

reboot and come back online with the new Network Settings.

•

Change the IP address in the browser address bar to match the Static IP

address just configured and hit enter. You should be prompted to login

to the CNT-IP-2 device again with the same username and password as

described above.

4.2 Configuration Files

Configuring multiple CNT-IP-2 systems can be time consuming. We have

made it easier by allowing you to download (save) a configuration file and

upload it to other systems, requiring only minimal changes.
All configuration including settings, users, actions, groups, buttons, events

and state information are stored in a file called ‘CONFIG.JS’.
This file can be downloaded or uploaded through the IP Manager interface

on the Configuration->System->Basic Tab.

Advertising