Hanna Instruments HI 93414 - Manual (Page 42)

42
SETUP
Setup mode allows viewing and modifying the instrument parameters.
The blinking “
CAL” tag during setup mode suggest to press CAL/CHECK for parameters editing.
SET EPA COMPLIANCE MODE (for turbidimeter range only)
When EPA compliance reading is ON, “ EPA” tag is displayed on the LCD and the reported values are
rounded to meet EPA reporting requirements.
• To start edit the EPA mode, press CAL/CHECK
when “ EPA” compliance reading panel is
displayed. The parameter setting and “ CFM”
tag will start blinking.
• Press the ▲ or ▼ keys to set ON or OFF the
EPA compliance mode.
• Press LOG/CFM to save the setting. The new
selected option of the parameter will be
displayed on the LCD. Alternatively, press
CAL/
CHECK to exit without saving the new settings.
• To enter/exit SETUP, press SETUP/DEL.
• To select the parameter to be edit, press ▲ or
▼ keys until the desired panel is displayed.
Press ▲ or ▼ keys also to change the value
of a parameter.
• To start/stop editing a parameter, press CAL/
CHECK.
• To save the new selected value of a parameter,
press LOG/CFM.